Pre-Trigger Remote Cable
For remotely triggering Canon cameras equipped with an N3 Remote Terminal
Cable length: 3' (91.5 cm)
From 1/8" (3.5 mm) Mono Miniphone
Via Pre-Trigger Switch
To Canon N3 Remote Terminal
International Catalog Number: CM-N3-P
US Catalog Number: 804-511
· Plus II
· MultiMAX with no ACC port
· Use the CM-N3-ACC for the PlusX Plus III, MultiMAX with ACC port, or FlexTT5 radios
Description: This cable contains a pre-trigger switch. When enabled, the camera behaves as if the camera's shutter release button were held half-pressed continuously. This makes the camera respond more quickly and consistently, but also consumes the camera's batteries much more quickly. When disabled, this cable functions identically to the CM-N3.
This –P cable works with most PocketWizard radios. This pre-trigger cable has a switch that allows you to toggle half-press on or off at the camera position, but not remotely.
A standard cable works with most PocketWizard radios but has no half-press control, and is for basic remote triggering only.
A –ACC cable allows a compatible PocketWizard radio to independently control both half-press and full-press functions, as well as relay E-TTL signals to compatible flashes when using FlexTT5s.
Compatible with the following radios:
Plus X: Use this cable to remotely fire your camera.
Plus III : This cable can remotely fire your camera and control half-press function at the camera’s position. Use a –ACC cable for best results and to have half-press capability from the transmitting radio.
MultiMAX with no –ACC port: Use this cable to remotely fire your camera and control half-press function at the camera’s position.
MultiMAX with –ACC port: This cable can remotely fire your camera but cannot wake up the camera in a remote zone. Use a –ACC cable for best results
FlexTT5: This cable can remotely fire your camera and control half-press function at the camera’s position, but your remote camera will not be able to relay an E-TTL signal to Speedlites. Use a –ACC cable for best results. Learn more here
Please see our PocketWizard Wiki for more details.
Compatible with cameras using Canon's N3 Remote Terminal including:
|EOS-1D Mark II||EOS-1V-HS
|EOS-1D Mark IIN||EOS-3
|EOS-1D Mark III||EOS 5D
|EOS-1D Mark IV
||EOS 5D Mark II||EOS D30|
|EOS-1Ds||EOS 5D Mark III||EOS D60|
|EOS-1Ds Mark II||EOS 6D
|EOS-1Ds Mark III||EOS 7D|
* Not for use with DCS Pro SLR/c
Trademarks are the property of their respective owners.
See Wiki for Compatibility details.