N-MCDC2-P

Pre-Trigger Remote Cable
For connecting a Plus II or MultiMAX with no ACC port to a Nikon MC-DC2 remote terminal, through a Pre-Trigger switch

Cable length: 3' (91.5 cm)

From 1/8" (3.5 mm) Mono Miniphone

Via Pre-Trigger Switch

To Nikon MC-DC2 remote shutter release terminal

International Catalog Number: NMCDC2-P

US Catalog Number: 804-522

PocketWizard Compatibility:         

· Plus II

· MultiMAX with no ACC port

· Use the N-MCDC2-ACC for the PlusX, Plus III, MultiMAX with ACC port, or  FlexTT5 radios

Description:  This cable contains a pre-trigger switch.  When enabled, the camera behaves as if the camera's shutter release button were held half-pressed continuously. This makes the camera respond more quickly and consistently, but also consumes the camera's batteries much more quickly. When disabled, this cable functions identically to the N-MCDC2.

This –P cable works with most PocketWizard radios. This pre-trigger cable has a switch that allows you to toggle half-press on or off at the camera position, but not remotely.

A standard cable works with most PocketWizard radios but has no half-press control, and is for basic remote triggering only.

A –ACC cable allows a compatible PocketWizard radio to independently control both half-press and full-press functions, as well as relay E-TTL signals to compatible flashes when using FlexTT5s.

 

Compatible with the following radios:

Plus II: Use this cable to remotely fire your camera.

Plus III : This cable can remotely fire your camera and control half-press function at the camera’s position.  Use a –ACC cable for best results and to have half-press capability from the transmitting radio.

MultiMAX with no –ACC port:  Use this cable to remotely fire your camera and control half-press function at the camera’s position.

MultiMAX with –ACC port: This cable can remotely fire your camera but cannot wake up the camera in a remote zone.  Use a –ACC cable for best results

FlexTT5:  This cable can remotely fire your camera and control half-press function at the camera’s position, but your remote camera will not be able to relay an E-TTL signal to Speedlites.  Use a –ACC cable for best results.  Learn more here

Compatible with cameras using Nikons MC-DC2 remote terminal including:

Nikon

D90

D600

D3100

D3200

D5000

D5100

D5200

D7000

Not for Nikon D70s or D80-use NM4-P instead.

Trademarks are the property of their respective owners.